Could I help you?

ASTM D8257/D8257M-20

ASTM D8257/D8257M-20 Standard Specification for Mechanically Attached Polymeric Roof Underlayment Used in Steep Slope Roofing

standard by ASTM International, 12/15/2020

More details

Reduced price!
M00068462
New product
Limited time offer:

$20.70

$46.00

-55%

In stock

- +

Add to compare

 
More info

Full Description

1.1''This specification addresses mechanically attached polymeric roof underlayment used in steep slope roofing.

1.2''The objective of this specification is to provide a finished product that will be used as a water-shedding underlayment layer on steep sloped roofs prior to and after installation of the primary roof covering.

1.3''The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4''This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5''This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
Custom tab

This is a custom block edited from admin panel.You can insert any content here.

30 other products in the same category:

Compare 0

No products

To be determined Shipping
$0.00 Total

Check out