No products
ASTM F1005-91(2013)
ASTM F1005-91(2013) Standard Practice for HVAC Duct Shapes; Identification and Description of Design Configuration
standard by ASTM International, 10/01/2013
Full Description
1.1This practice covers the identification of design configurations and descriptive nomenclature for sheetmetal HVAC ductwork shapes frequently used in shipbuilding. This practice also covers parametric dimensions of these shapes. (See Table 1.)
TABLE 1 HVAC Standard Nomenclature and Numbering System| 1.Straight: |
| 1.1Straight-round |
| 1.2Straight-flat oval |
| 1.3Straight-rectangular |
| 2.Offset: |
| 2.1Offset-round |
| 2.2.1Offset-flat oval-long axis |
| 2.2.2Offset-flat oval-short axis |
| 2.3.1Offset-rectangular-without splitters |
| 2.3.2Offset-rectangular-with splitters |
| 2.4.1Offset-ogee-without splitters |
| 2.4.2Offset-ogee-with splitters |
| 2.5.1Offset-rectangular reducing-without |
| splitters |
| 2.5.2Offset-rectangular reducing-with splitters |
| 3.Elbow: |
| 3.1Elbow-round |
| 3.2.1Elbow-flat oval-long axis |
| 3.2.2Elbow-flat oval-short axis |
| 3.3.1Elbow-rectangular-without splitters |
| 3.3.2Elbow-rectangular-with splitters |
| 3.4.1Elbow-rectangular reducing-without |
| splitters |
| 3.4.2Elbow-rectangular reducing-with splitters |
| 3.5.1Elbow-rectangular transition-without |
| splitters |
| 3.5.2Elbow-rectangular transition-with splitters |
| 4.Vaned Turn: |
| 4.1Vaned turn |
| 5.Reducer: |
| 5.1Reducer-round |
| 5.2Reducer-flat oval |
| 5.3Reducer-rectangular |
| 6.Transition and Bellmouth: |
| 6.1Transition-flat oval to round |
| 6.2Transition-rectangular to round |
| 6.3Transition-rectangular to flat oval |
| 6.4Transition-rectangular to radius corner |
| 6.5Transition-radius corner to flat oval |
| 6.6.1Bellmouth-round |
| 6.6.2Bellmouth-rectangular |
| 7.Branch: |
| 7.1.1Branch-round-on equal diameter round |
| 7.1.2Branch-round-on larger diameter round |
| 7.1.3Branch-round-on round reducer |
| 7.1.4Branch-round-on rectangular straight |
| 7.1.5Branch-round-on rectangular reducer |
| 7.1.6Branch-round Y |
| 7.1.7Branch-rectangular to round-Y |
| 7.2.1Branch-rectangular-on rectangular straight |
| 7.2.2Branch-rectangular-on rectangular reducer |
1.2This practice does not cover the location of seams or joints within a shape or the method of joining shapes together.
1.3Since this practice is not measurement sensitive, it is applicable whether inch-pound or SI metric dimensions are used.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
