Full Description

1.1This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.

1.2This practice is applicable to thermoplastic pipe and fittings.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.